W/Harness Inspection

AFLS(LED)
B1302 Gearbox Signal Fault-CAN Signal - Inspection/Repair:_:W/Harness Inspection

W/Harness Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?





CAN communication circuit inspection (AFLS ECU <-> TCU)
1. Ignition "OFF"
2. Disconnect Steering angle sensor connector and AFLS ECU connector.
3. Measure the resistance between CAN-HIGH terminal of TCU harness connector and CAN-HIGH terminal of AFLS ECU harness connector.
4. Measure the resistance between CAN-LOW terminal of TCU harness connector and CAN-LOW terminal of AFLS ECU harness connector.

Specification :below 1Ohms




5. Is the measured resistance within specification ?