W/Harness Inspection

AFLS(LED)
B1909 Rear sensor signal fault - Inspection/Repair:_:W/Harness Inspection

W/Harness Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Signal circuit Inspection

Check Short to battery
1. Ignition "OFF"
2. Disconnect Front height sensor connector.
3. Ignition "ON"
4. Measure the voltage between Rear height sensor's signal wiring of wiring harness side and chassis ground.

Specification :below 5V




5. Is "voltage" display near the specified value?





Check short between power circuit and signal circuit
1. Ignition "OFF"
2. Disconnect Rear height sensor connector and ECU connector.
3. Measure the resistance between Rear height sensor's signal wiring of wiring harness side and Power terminal.

Specification :Discontinuity (Infinite Ohms )




4. Is the measured resistance within specification ?






Ground circuit Inspection

Check open in ground circuit
1. Ignition "OFF"
2. Disconnect Rear height sensor connector and ECU connector.
3. Measure the resistance between Rear height sensor's ground wiring of wiring harness side and chassis ground.

Specification :below 1Ohms




4. Is the measured resistance within specification ?