Component Inspection

Electronic Stability Control
C1623 CAN Time-out Steering Angle Sensor - Inspection/Repair:_:Component Inspection

Component Inspection

1. IG "OFF"
2. IG "ON"
3. After connecting scantool, check DTC on the scantool.
4. Using scantool, Erase the DTCs.
5. Operate the steering angle sensor's calibration by scantool.
6. Check if the signal value of the steering angle sensor is within ±2° when the angle of the tire is 0° on the scantool.
7. Is the value of the steering angle sensor out of the normal range?