W/Harness Inspection

Automatic Transaxle
P076F Gear 7 Incorrect Ratio - Inspection/Repair:_:W/Harness Inspection

Signal Circuit Inspection

1. Connect GDS to Data Link Connector(DLC).
2. Ignition "ON" & Engine "ON".
3. Selet "Currnet Data"mode and monitor "Engine speed, Input speed sensor, Output speed sensor and Gear position" parameter used select option.
4. Engine speed up to about 2000rpm and check Input speed&Output speed are within specific at 7th speed of gear.

Specification :2nd~8th :|Input speed sensor-Output speed sensor Gear ratio| ≥ 200rpm




5. Are measured Input speed&Output speed within specifiction?