Repair Procedures

Removal

WARNING:
System is under high pressure when the engine is hot. To avoid danger of releasing scalding engine coolant, remove the cap only when the engine is cool.

1. Disconnect the negative terminal from the battery.

Tightening torque :4.0 - 6.0N.m (0.4 - 0.6kgf.m, 3.0 - 4.4lb-ft)

2. Remove the engine cover (A).




3. Remove the engine side cover.
4. Loosen the drain plug and drain the engine coolant.
5. Remove the air duct (A), and the air cleaner assembly (B).

Tightening torque
Hose clamp bolt: 2.9 - 4.9N.m (0.3 - 0.5kgf.m, 2.2 - 3.6lb-ft)
Air cleaner assembly bolts: 7.8 - 9.8N.m (0.8 - 1.0kgf.m, 5.8 - 7.2lb-ft)




6. Disconnect the radiator upper hose (A) and lower hose (B).




7. Remove the radiator & cooling fan assembly from the vehicle.
8. Disconnect the ATF cooler hoses (A).




9. Disconnect the fan motor connector (A).
10. Remove the radiator & condenser mounting bolt (B).




11. Remove the radiator & cooling fan assembly from the vehicle.

Installation

1. Installation is reverse order of removal.
2. Connect the fan motor connector.
3. Install the radiator upper hose & lower hose, and connect the ATF cooler hoses.
4. Fill the radiator with coolant and check for leaks.