Rear Assist Arm

Replacement

1. Remove the rear wheel & tire.

Tightening torque:
90 - 110N.m (9.0 - 11.0kgf.m, 65 - 80lb-ft)

2. Remove the split pin and castle nuts.

Tightening torque:
80 - 90N.m (8.0 - 9.0kgf.m, 58 - 65lb-ft)




3. Disconnect the rear assist arm with the rear carrier using a SST (09568-2J100).




4. Loosen the bolt & lock nuts.

Tightening torque:
100 - 120N.m (10.0 - 12.0kgf.m, 72 - 87lb-ft)




5. Installation is the reverse of removal.
6. Check the alignment.


Inspection

1. Check the bushing for wear and deterioration.
2. Check the ball joint for rotating torque.
3. Check the assist arm for deformation.