W/Harness Inspection

Electronic Stability Control
C1702 Variant Coding Error - Inspection/Repair:_:W/Harness Inspection

Terminal and Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Variant Coding

1. Check for improper installation of EMS/TCU/ESC.
2. Connect GDS to Data Link Connector(DLC).
3. Ignition "ON" & Engine "OFF".
4. Perform variant coding. (Figure 1).
5. Disconnect GDS.
6. Ignition "OFF" and then ignition "ON". Go to "Component Inspection" Procedure.