Fuel Pump

Inspection

[Fuel pump]
1. Turn the ignition switch OFF, and then remove battery (-) cable.
2. Remove the fuel pump assembly.
3. Check motor (A) operation by connecting power (4) and ground (5).










[Fuel sender]
1. Turn the ignition switch OFF, and then remove battery (-) cable.
2. Remove the fuel pump assembly.
3. Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.









4. Also check that the resistance changes smoothly when the float is moved from "E" to "F".






Removal

1. Release the residual pressure in fuel line (Refer to "Release Residual Pressure in Fuel Line" in this group).
2. Remove the fuel pump service cover (A) in the trunk.




3. Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
4. Disconnect the fuel feed tube quick connector (C) and the vapor tube quick-connector (D).
5. Remove locking ring (E) by use the special service tool [SST No. : 09310-2S200].




6. Disconnector the vapor tube quick-connector (A) at the fuel pump, and then remove the fuel pump from the fuel tank.










Installation

1. Installation is reverse of removal.

CAUTION:
Be careful of fuel pump direction (Refer to the groove in the fuel tank).