Repair Procedures

Replacement

NOTE:
- After remove the rear combination lamp.
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts your hands.
- Put on gloves to protect your hands.
- Take care not bend or scratch the cover and other parts.

1. Remove the following items.
A. Luggage cover mat

B. Transverse trim

C. Luggage side trim

2. Disconnect the connector (A), and then remove the rear combination lamp mounting nuts.
3. Remove the rear combination lamp (B).




4. After loosening the rear bumper side's mounting clip and screws, then disconnect the side's.




5. Loosen the mounting screws and clips.




6. Loosen the mounting bolts.




7. Disconnect the connector (A).




8. Loosen the rear bumper cover mounting screws and clips, and then remove the rear bumper cover (A).




9. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.