W/Harness Inspection

Automatic Transaxle(DCT)
P0910 Gate Select Actuator Circuit/Open - Inspection/Repair:_:W/Harness Inspection

Terminal & Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Power Circuit Inspection

1. Ignition "ON" & Engine "OFF".
2. Disconnect the "Select Motor" connector.
3. Measure voltage between "Motor Power" terminal of the Clutch Motor1 harness connector and chassis ground.

Specification :approx. 12V




4. Is voltage within specifications?






Signal Circuit Inspection

1. Ignition "ON" & Engine "OFF".
2. Disconnect the "Select Motor" connector.
3. Measure voltage between "7" terminal of the Select Motor harness connector and chassis ground.

Specification :approx. 0 V




4. Is voltage within specifications?






Ground Circuit Inspection

1. Ignition "ON" & Engine "OFF".
2. Disconnect the "Select Motor" connector.
3. Measure voltage between "8" terminal of the Select Motor harness connector and chassis ground.

Specification :approx. 0 V




4. Is voltage within specifications?