W/Harness Inspection

Automatic Transaxle(DCT)
P2765 Input/Turbine Speed Sensor - Inspection/Repair:_:W/Harness Inspection

Terminal & Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Power Circuit Inspection

1. Ignition "ON" & Engine "OFF".
2. Disconnect the "INPUT SPEED SENSOR2" connector.
3. Measure voltage between "Power" terminal of the INPUT SPEED SENSOR 2 harness connector and chassis ground.

Specification :approx. 12V




[1. Signal, 2. -, 3. Power]
4. Is voltage within specifications?






Signal Circuit Inspection

1. Ignition "ON" & Engine "OFF".
2. Disconnect the "INPUT SPEED SENSOR2" connector.
3. Measure resistance between "Signal" terminal of the INPUT SPEED SENSOR2 harness connector and chassis ground.

Specification :approx. 0V




[1. Signal, 2. -, 3. Power]
4. Is voltage within specifications?