W/Harness Inspection

Automatic Transaxle(DCT)
U1117 High Speed CAN 2 Communication (EMS-DCT) - Inspection/Repair:_:W/Harness Inspection

Terminal & Connector Inspection

1. Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
3. Has a problem been found?






Signal Circuit Inspection

1. Ignition "ON" & Engine "OFF".
2. Disconnect the "TCM" and "ABS ECM" connector.
3. Measure Resistence between terminal "30" and "31" of the TCM harness connector.

Specification :Approx. 120 Ohms ± 10 %




4. Is measured resistance within specifications?