Repair procedures

Replacement

CAUTION:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.
- Put on gloves to protect your hands.

1. Remove the luggage side trim.

2. Disconnect the rear bumper main connector (A).




3. Disconnect the connector (B), and then loosen the rear combination lamp mounting nuts.
4. Remove the rear combination lamp (A).




5. Remove the rear bumper lower mounting clips.




6. Loosen the mounting bolts.




7. After loosening the rear bumper side's mounting screws, then disconnect the side's.




8. After loosening the mounting screw and clips, then remove the rear bumper cover (A).




9. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.
- Make sure the connector is plugged in properly.