Engine Mount: Service and Repair

Removal and Installation

[Engine mounting support bracket]
1. Install the jack to the edge of upper oil pan (A) to support the engine.





NOTE:
Insert the rubber block between jack and upper oil pan.

2. Disconnect the ground cable (A), and then remove the engine mounting support bracket (B).

Tightening torque:
88.3 - 107.9N.m (9.0 - 11.0kgf.m, 65.1 - 79.6lb-ft)




3. Install in the reverse order of removal.
[Engine mounting bracket]
1. Remove the reservoir tank.

2. Remove the engine mounting support bracket (A).

Tightening torque:
88.3 - 107.9N.m (9.0 - 11.0kgf.m, 65.1 - 79.6lb-ft)

3. Remove the engine mounting bracket (B).

Tightening torque:
58.8 - 73.5N.m (6.0 - 7.5kgf.m, 43.3 - 54.2lb-ft)




4. Install in the reverse order of removal.
[Roll rod bracket]
1. Remove the engine room under cover.
2. Remove the roll rod bracket (A).

Tightening torque
Bolt (B):
107.9 - 127.5N.m (11.0 - 13.0kgf.m, 79.6 - 94.0lb-ft)
Bolts (C):
49.0 - 63.7N.m ( 5.0 - 6.5kgf.m, 36.2 - 47.0lb-ft)





CAUTION:
Do not reuse : Bolt (B) (Lactated)

3. Install in the reverse order of removal.