Repair procedures

Replacement

[M/T]

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

NOTE:
- Take care not to scratch the body surface.

1. Using a screwdriver or remover, remove the crash pad center garnish [LH, RH] (A).




2. After loosening the mounting screw, then remove the console garnish [LH, RH] (A).




3. Disconnect the gear boots (A).




4. Using a screwdriver or remover, remove the console upper cover (A).




5. Disconnect the connector (A).




6. Remove the console tray met (A).




7. After loosening the mounting screws and bolts, then remove the floor console assembly (A).




8. Disconnect the EPB switch connector (A).




9. Detach the clips, then remove the console side cover (A).
[LH]




[RH]




10. Install in the reverse order of removal.

CAUTION:
- Make sure the connector are connected in properly.
- Replace any damage clips.

[A/T]

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

NOTE:
- Take care not to scratch the body surface.

1. Using a screwdriver or remover, remove the crash pad center garnish [LH, RH] (A).




2. After loosening the mounting screw, then remove the console garnish [LH, RH] (A).




3. Disconnect the gear boots (A).




4. Using a screwdriver or remover, remove the console upper cover (A).




5. Disconnect the connector (A).




6. Remove the console tray met (A).




7. After loosening the mounting screws and bolts, then remove the floor console assembly (A).




8. Disconnect the EPB switch connector (A).




9. Detach the clips, then remove the console side cover (A).
[LH]




[RH]




10. Install in the reverse order of removal.

CAUTION:
- Make sure the connector are connected in properly.
- Replace any damage clips.