Repair procedures

Replacement

CAUTION:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.

NOTE:
- Take care not to scratch the body surface.

1. Using a screwdriver or remover, remove the crash pad side cover [LH] (A).




2. After loosening the mounting screws, then remove the crash pad lower panel (A).




3. Disconnect the diagnosis connector (A).




4. Install in the reverse order of removal.

CAUTION:
- Make sure the connector are connected in properly.
- Replace any damaged clips.