Repair procedures

Adjustment

Inspect Glass Alignment
1. Check for abnormal noise or bending during operation.
2. With the sunroof fully closed, check for water leakage.
3. The roof panel (B) should be even with the movable glass (A) weatherstrip, to within the standard value "E" all the way around. If not, make the following adjustment.

Tightening torque :
Standard value "E" [mm(in.)]
(1) Front edge : 1.2 mm (0.0472 in.)
(2) Rear edge : 1.0 mm (0.0394 in.)




4. If the position is not as specified, lightly loosen the glass adjusting screws (A) to adjust the glass height and tighten it.

NOTE:
- Do not damage the screws.





Operating The Panorama Sunroof Emergency Handle
1. Use the panorama sunroof emergency handle to close and open the panorama sunroof manually for the following case only.
A. To close the panorama sunroof before driving a vehicle in a rainy day or on the highway if the panorama sunroof can not be closed due to failure of the panorama sunroof motor or controller.
2. Operating method.
A. Remove the roof trim.
B. Push the emergency handle up into the hexagonal drive of the panorama sunroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
C. Carefully turn the emergency handle clockwise to close the panorama sunroof.
D. After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
E. A 5mm hex socket may be used in place of the emergency handle, with a" Speeder" type handle.

NOTE:
- Do not use power tools to operate the panorama sunroof.
- Damaged to the components may occur.