Repair procedures

Replacement

CAUTION:
- Put on gloves to protect your hands.

NOTE:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.

1. Remove the front seat assembly.

2. Remove the front seat shield outer cover.

3. Push the lock pin (B), remove the front seat headrest (A).




4. Remove the front seat lower protector (A).




5. Disconnect the front seat heater connector (A).




6. To disengage the lock pin (C), lift up the front seat back board (A) to the arrow direction with holding the bottom place (B).

NOTE:
- Be careful not to damage the lock pin.




7. Push the protector (A) by the front seat back frame.




8. Remove the front seat side protector (A).




9. Pull out the headrest guides (A) while pinching the end of the guides, and remove them.




10. Remove the front seat back cover (A) from the front seat frame.




11. After removing the velcro tape (B) on the front of seat back and remove the front seat back cover (A).




12. Install in the reverse order of removal.

CAUTION:
- Replace any damaged clips.
- Make sure the connector is plugged in properly.