Repair procedures

Replacement

[LH]

CAUTION:
- Put on gloves to protect your hands.

NOTE:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.

1. Remove the rear seat back assembly [LH].

2. Push the lock pin (B), remove the rear seat headrest (A).




3. Using a screwdriver or remover, remove the rear seat folding lever (A).




4. After loosening the mounting screws, then remove the rear seat latch cover (A).




5. Disconnect the rear seat back cover protector (A).




6. Disconnect the rear seat back upper protector (A).




7. Pull out the headrest guides (A) while pinching the end of the guides, and remove them.




8. Remove the rear seat back cover (A) from the rear seat back frame (B).




9. After removing the velcro tape (B) on the rear of seat back and remove the rear seat back cover (A).




10. Install in the reverse order of removal.

CAUTION:
- Replace any damaged clips.

[RH]

CAUTION:
- Put on gloves to protect your hands.

NOTE:
- Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
- Take care not to bend or scratch the trim and panels.

1. Remove the rear seat back assembly [RH].

2. Push the lock pin (B), remove the rear seat headrest (A).




3. Using a long nose, remove the rock pin (B) and rear back armrest (A).




4. After loosening the mounting screws, then remove the rear back armrest panel (A).




5. Using a screwdriver or remover, remove the rear seat folding lever (A).




6. Using a screwdriver or remover, remove the rear center seat belt upper anchor cover (A).




7. After loosening the mounting screws, then remove the rear seat latch cover (A).




8. Disconnect the rear seat back cover protector (A).




9. Disconnect the rear seat back upper protector (A).




10. Pull out the headrest guides (A) while pinching the end of the guides, and remove them.




11. Remove the rear seat back cover (A) from the rear seat back frame (B).




12. After removing the velcro tape (B) on the rear of seat back and remove the rear seat back cover (A).




13. Install in the reverse order of removal.

CAUTION:
- Replace any damaged clips.