Repair procedures

Replacement

1. Remove the front seat track mounting cover.
2. After loosening the mounting bolts, remove the front seat assembly (A).

Tightening torque :
34.3 - 53.9 N.m (3.5 - 5.5 kgf.m, 25.3 - 39.8 lb-ft)




3. Disconnect the seat buckle connector (A), seat warmer & power seat connector (B), SAB connector(C), PODS connector (D).
[Driver's]




[Passenger's]




4. Install in the reverse order of removal.

CAUTION:
- SEAT MOUNTING BOLT INSTALLATION PROCEDURE
- Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
- Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
- Set the seat into the most rearward position. Check the front mounting bolt completely.
- Check that the seat operates to and fro smoothly and the locking portion locks properly.