Repair Procedures

Inspection

Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace it.

Horn Relay Inspection
1. Remove the horn relay (A) from the engine room relay box.
2. There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
3. There should be no continuity between the No.30 and No.87 terminals when power is disconnected.










Removal

Horn (High pitch)
1. Disconnect the negative (-) battery terminal.
2. Remove the left front wheel guard.
3. Remove the mounting bolt and disconnect the horn connector (B), then remove the horn (A).





Horn (Low pitch)
1. Disconnect the negative (-) battery terminal.
2. Remove the under cover.
3. Remove the mounting bolt and disconnect the horn connector (B), then remove the horn (A).






Installation

Horn (High pitch)
1. Install the horn after connecting the horn connector.
2. Install the left front wheel guard.
3. Connect the negative (-) battery terminal.

Horn (Low pitch)
1. Install the horn after connecting the horn connector.
2. Install the under cover.
3. Connect the negative (-) battery terminal.