Repair Procedures

Removal and Installation

1. Disconnect the battery negative terminal.
2. Disconnect the ignition coil connectors (A).





NOTE:
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).





3. Remove the ignition coils (A).

Tightening torque :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)




4. Installation is reverse order of removal.

Inspection

1. Measure the primary coil resistance between terminals (+) and (-).

Standard value:0.75 Ohms ± 15%