Repair procedures

Replacement

NOTE:
- When installing the belt, make sure not to damage the retractor.

1. Remove the luggage side trim.

2. Remove the rear pillar trim.

3. After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




4. After loosening the mounting bolt, then remove the rear seat belt retractor (A).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




5. Install in the reverse order of removal.

CAUTION:
- Replace any damaged clips.
- Make sure the connector is plugged in properly.