Repair Procedures

Inspection

Smart Key Unit
- Refer to Smart key system - "Smart key Diagnostic"

Smart key Switch
- Refer to Smart key system - "Smart key Diagnostic"

Antenna
- Refer to Smart key system - "Smart key Diagnostic"

Tailgate Open Switch
1. Check for continuity between the Trunk lid open switch terminals.




2. If continuity is not specified, inspect the switch






Removal

Smart key unit
1. Disconnect the negative(-) battery terminal.
2. Remove the glove box housing.

3. Remove the smart key unit (A) with loosening bolt and nut, then disconnect the connector.





Interior #1 antenna

NOTE:
Take care not to scratch the crash pad and related parts.

1. Disconnect the negative(-) battery terminal.
2. Remove the floor console assembly.

3. Disconnect the connector ,then remove the interior #1 antenna (A) with loosening 2 screws.





Interior #2 antenna

NOTE:
Take care not to scratch the crash pad and related parts.

1. Disconnect the negative(-) battery terminal.
2. Remove the floor console assembly.

3. Disconnect the connector ,then remove the interior #2 antenna (A) with loosening 2 screws.





Trunk antenna
1. Disconnect the negative(-) battery terminal.
2. Remove the rear transverse trim.

3. Disconnect the connector ,then remove the trunk antenna (A) with loosening 2 nuts.





Exterior Bumper Antenna
1. Disconnect the negative(-) battery terminal.
2. Remove the rear bumper beam assembly.

3. Disconnect the connector ,then remove the rear bumper antenna (A) with loosening 2 screws.





Buzzer
1. Disconnect the negative(-) battery terminal.
2. Remove the front left wheel guard.
3. Remove the buzzer (A) after disconnecting the connector.





Door outside handle
1. Disconnect the negative(-) battery terminal.
2. Loosen the mounting bolt after removing the holder plug (B).
3. Remove the front door outside hand cover (A).




4. Remove the front door outside handle (A) by sliding it rearward.




5. Disconnect the front door outside handle connector (A).





Tailgate open switch
1. Disconnect the negative(-) battery terminal.
2. Remove the tailgate trim.

3. Disconnect the tailgate open switch connector (A).






Installation

Smart Key Unit
1. Install the smart key unit.
2. Connect the connector and install the smart key unit.
3. Install the glove box housing.
4. Install the negative (-) battery terminal and check the smart key system.

Interior #1 Antenna
1. Install the interior #1 antenna.
2. Install the floor console assembly.
3. Install the negative (-) battery terminal and check the smart key system.

Interior #2 Antenna
1. Install the interior #2 antenna.
2. Install the floor console assembly.
3. Install the negative (-) battery terminal and check the smart key system.

Trunk Antenna
1. Install the trunk antenna.
2. Install the rear transverse trim.
3. Install the negative (-) battery terminal and check the smart key system.

Exterior Bumper Antenna
1. Install the exterior bumper antenna.
2. Install the rear bumper beam and bumper.
3. Install the negative (-) battery terminal and check the smart key system.

Buzzer
1. Install the buzzer.
2. Install the front left wheel guard.
3. Install the negative (-) battery terminal and check the smart key system.

Door Outside Handle
1. Install the door outside handle.
2. Install the door trim.
3. Install the negative (-) battery terminal and check the smart key system.

Trunk open switch
1. Install the tailgate open switch.
2. Install the tailgate trim.
3. Install the negative (-) battery terminal and check the smart key system.