Repair Procedures

Inspection

1. Check the select cable for proper operation and for damage.
2. Check the shift cable for proper operation and for damage.
3. Check the boots for damage.
4. Check the boots for wear abrasion sticking, restricted movement or damage.

Removal

1. Remove the floor console assembly.

2. Remove the air duct (A).




3. Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.




4. Remove the shift cable (B) after removing the clip (A).




5. Remove the cable guide (A) from lever assembly after pulling in the direction of the arrow.




6. Remove the crash pad and cowl cross bar.

7. Remove the heater unit.

8. Remove the retainer (A) after loosen the nut (B).




9. Remove the following items.
A. Engine cover.

B. Air cleaner assembly and air duct.

C. Battery and battery tray.

10. Remove the shift & select cable.
(1) Remove the pin (A) and washer (B).
(2) Make unlock clip (C) and then remove the shift & select cable and the clip (C) from the bracket.





NOTE:
- Do not reuse the clip (C).

11. Remove the shift cable at cabin room.

Installation

CAUTION:
- When installing, set room side Shift lever and T/M side lever to N position.

1. Install the control cable (B) and clip (A) on the bracket.




2. Install the washer (B) and pin (A).




3. Tighten the nut (B) after install the retainer (A).

Tightening torque:
11.8 - 14.7 N.m (1.2 - 1.5 kgf.m, 8.7 - 10.8 lb-ft)




4. Install the crash pad and cowl cross bar.

5. Install the heater unit.

6. Install the cable guide (B) on lever assembly.




7. Install the shift cable (B) and clip (A).




8. Shift lever to "3rd".
9. Install the snap pin (A) after install the select cable (B).

CAUTION:
- Install the snap pin (A) after adjust the select cable (B).





10. Install the air duct (A).




11. Install the floor console assembly.

12. Install the following items.
A. Engine cover.

B. Air cleaner assembly and air duct.

C. Battery and battery tray.


Adjustment

Select cable adjustment
1. Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.




2. Shift the shift lever to 3rd gear.
3. Move the slide clip (B) of guide member (A) in the direction as shown in the illustration.




4. Install the select cable (A).




5. Insert the slide clip (A) in the direction as shown in the illustration and then install the snap pin (B).