Repair Procedures
Replacement
Sunvisor Replacement
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.
1. Loosen the mounting screws, then remove the sunvisor (A) and retainer (B).
2. Disconnect the connector (C).
3. Installation is the reverse of removal.
Assist Handle Replacement
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.
1. Remove the covers.
2. After loosening the mounting screws, then remove the assist handle (A).
3. Installation is the reverse of removal.
Overhead Console Replacement
1. Loosen the mounting screws, then remove the console assembly (A).
2. Disconnect the connector (B).
3. Installation is the reverse of removal.
NOTE:
- Make sure the connector is plugged in properly.
Room Lamp Replacement
1. Using a screwdriver, remove the cover (A).
2. Loosen the mounting screws, remove the room lamp (B).
3. Disconnect the connector (A).
4. Installation is the reverse of removal.
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.
- Make sure the connector is plugged in properly.
Hands Free Mic And Vanity Lamp Replacement
1. Using a screwdriver, remove the hands free mic (A) and vanity lamp (B).
2. Installation is the reverse of removal.
Roof Trim Assembly Replacement
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.
1. Remove the following items:
A. Front seat.
B. Rear seat.
C. Sunvisor.
D. Overhead console.
E. Room lamp.
F. Assist handle.
2. Remove the ECM room mirror cover (A).
3. Disconnect the connector (A).
4. Disconnect the main wiring driver`s connector (A).
5. Disconnect the main wiring passenger`s connector (B).
6. Using a screwdriver, remove the rear room lamp cover (A).
7. Loosen the mounting screws, then remove the rear room lamp (A).
8. Disconnect the connector (A).
9. Detach the clips, then remove the roof trim (A).
10. Installation is the reverse of removal.
NOTE:
- Replace any damage clips.