Repair Procedures

Replacement

Door Scuff Trim Replacement

NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.

1. Remove the door scuff trim (A).




2. Installation is the reverse of removal.

Front Pillar Trim Replacement

NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.

1. Remove the cap, then loosen the mounting screw.
2. Remove the front pillar trim (A).




3. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.

Cowl Side Trim Replacement

NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.

1. Remove the front door scuff trim.
2. Remove the hood latch release handle.
3. Remove the cowl side trim (A).




4. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Center Pillar Trim Replacement

NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.

1. Remove the front door scuff trim and rear door scuff trim.
2. Using a flat-trip screwdriver, remove the seat belt anchor pretensioner (A).




3. Remove the center lower pillar trim (A).




4. Remove the center upper pillar trim (B).




5. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Rear Pillar Trim Replacement

NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.

1. Remove the wheel house trim.
2. Remove the cap, then loosen the mounting screw.
3. Remove the rear pillar trim (A).




4. Installation is the reverse of removal.

NOTE:
- Replace any damaged clips.

Package Tray Trim Replacement
1. Remove the rear seat.
2. Using a screwdriver or remover, remove the rear seat assembly.
3. Remove the rear door scuff trim (A).




4. Loosen the mounting screws, then remove the rear wheel house trim (A).




5. Remove the cap, then loosen the mounting screw.
6. Remove the rear pillar trim.




7. Push the hook, remove the rear seat belt cover (A).




8. Remove the rear seat belt lower anchor (A).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




9. Loosen the mounting screws, then remove the package tray trim (A).




10. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.

Partition Tray Trim Replacement
1. Remove the rear seat assembly.
2. Detach the clips, then remove the package trim (A).




3. Loosen the mounting bolts, then remove the package pillar (A).




4. Installation is the reverse of removal.

NOTE:
- Replace any damage clips.