Repair Procedures

Replacement

CAUTION:
- Avoid suffering excessive impact.
- Do not entering the water into pin inside.
- Do not remove cap except assemble and disassemble.
- Do not pile up the parts.
- If weight of product is heavy, the wire should be disconnected.
- Do not move with hold the wire.

1. Removal the front bumper.

2. Removal the left head amp.

3. Removal the EHPS motor.

4. Disconnect the connector (A) & air hose (B).





NOTE:
- Work with time until air is discharged.
- Separate with push the air tube connected to center portion.

5. Remove the bracket bolt.








6. Disconnect the solenoid valve (A) from the compressor by loosening the bolt.




7. Installation is the reverse of removal.

CAUTION:
- Take care not to drop.
- Confirm the tube color in installation process.
- Confirm that whether the tube is escaped a not by puling it.
- Be careful not to disconnection of cable by its twist or excessive bending.
- Do not remove cap except assemble.
- Take care not to twisted.
- If disassemble the air tube connector, do not reuse it.
- Air tube marking takes care not to be came off.