Parking Brake Pedal: Service and Repair

Removal

Parking Brake Pedal

1. Remove the crash pad lower panel.
2. Remove the IPM after removing the nut and connector.
3. Disconnect the parking brake switch connector (A).




4. Remove the parking brake pedal mounting bolts and nut (B), then remove the parking brake pedal.




5. Remove the cable adjust nut (B) and cable guide (C). And then detach the parking brake cable after tightening the fixing clip (D) with cable tie.




6. Remove the floor console. .
7. Remove the crash pad and cowl cross bar assembly.
8. Remove the heater & blower unit.
9. Loosen the cable fixing nut (B) and detach the rear parking brake cable which connected equalizer. And then remove front parking brake cable (A).






Installation

Parking Brake Pedal

1. Install the parking brake cable (A).




2. Install the fixing clip (C), washer plain (D) and cable adjusting nut (B) after fixing the parking brake cable.




3. Install the parking brake pedal, and then install the parking brake pedal mounting bolts and nut (D).




4. Adjust the parking brake pedal stroke by turning the adjusting nut(A).
(1) Adjust the adjusting nut (A) so that parking brake pedal stroke is to be between 3 notches when operating effort is 196 N (20 kg.f, 44 lb) after full stroke operation of parking brake pedal over 3 times for setting parking wire.





CAUTION:
1. The parking brake adjustment must be carried out after adjusting the rear shoe.
2. After adjusting parking brake, notice following matter.
1) Must be free from clearance between adjusting nut and pin.
2) Check securely that the brake is not dragging.

5. Reconnect the parking brake switch connector(A).




6. Install the heater & blower unit.
7. Install the crash pad and cowl cross bar assembly.
8. Install the floor console. .