Accelerator Pedal: Service and Repair

Removal

1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2. Disconnect the accelerator position sensor connector (A).
3. Disconnect the accelerator control connector (B).
4. Remove the accelerator pedal in the direction of "Removal direction" in the figure after removing the installation bolt (B).










Installation

1. Installation is reverse of removal.

Accelerator pedal module installation bolt:
8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)