Repair Procedures

Replacement

Seat Assembly Replacement
1. After loosening the mounting bolts, then remove the rear seat assembly (A).

Tightening torque :
44.1 - 58.8 N.m (4.5 - 6.0 kgf.m, 32.5 - 43.4 lb-ft)




2. Disconnect the seat heater connectors (A).




3. Installation is the reverse of removal.

NOTE:
Seat mounting bolt and nut installation procedure.
- Tighten temporarily in the order of nut and bolt on the front of recliner hinge installation part.
- After completely tightening completely the bolt on the back of the recliner hinge installation part, tighten the bolt on the front of it completely.
- Setting down the seat cushion, tighten the mounting bolt of the cushion frame hinge.
- Check if reclining the seat and folding seat back operate smoothly.

Armrest Replacement
1. After loosening the mounting nuts, then remove the armrest(A).




2. Installation is the reverse of removal.