Repair Procedures
Replacement
Sunvisor Replacement
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.
1. Loosen the mounting screws, then remove the sunvisor (A) and retainer (B).
2. Installation is the reverse of removal.
Assist Handle Replacement
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.
1. Remove the covers (A) and screws, then remove the assist handle (B).
2. Installation is the reverse of removal.
Overhead Console Lamp Replacement
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.
1. After loosening the mounting screws, remove the overhead console (A).
2. Disconnect the connectors (B).
3. Installation is the reverse of removal.
Room Lamp Replacement
NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Put on gloves to protect your hands.
1. Remove the covers (A).
2. After loosening the mounting screws, then remove the room lamp (B).
3. Disconnect the connector (A).
4. Installation is the reverse of removal.
Hands Free Mic and Lamp Replacement
1. Remove the hands free mic (A) and lamp (B).
2. Installation is the reverse of removal.
Roof Trim Replacement
NOTE:
- Put on gloves to protect your hands.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to bend or scratch the trim and panels.
1. Remove the following items :
A. Rear seat cushion
B. Front door scuff trim & Rear door scuff trim
C. Front pillar trim
D. Center pillar lower trim & Center pillar upper trim
E. Rear pillar trim
F. Sunvisor
G. Overhead console
H. Room lamp
I. Assist handle
2. Disconnect the connector (A).
[Driver's]
[Passenger's]
3. Disconnect the clips.
4. Remove the roof trim (A).
5. Installation is the reverse of removal.
NOTE:
- Replace any damage clips.