Clutch Actuator Motor 1 (Odd Gear)

Inspection

1. Turn off the ignition switch.
2. Disconnect the clutch motor connector.
3. Measure the resistance on the clutch motor terminal.
4. Refer to the specifications and check that the measured resistance is as specified.

Removal

1. Remove the following parts first:
A. Air cleaner assembly and air duct

B. Battery and tray

C. ECM

2. Disconnect the clutch actuator motor connector (A).




3. Loosen the mounting screw, and then remove the clutch actuator motor (A).

Tightening Torque :
4.4 - 5.4 N.m (0.45 - 0.55 kgf.m, 3.3 - 4.0 lb-ft)





Installation

1. Installation is the reverse of removal.

NOTE:
Clutch actuator spline (A) with grease before installation.
Specified grease [CSG-101M (0.1ml)]