Component Inspection

FUEL WARNING LAMP SENSOR CHECK
^ It will take a short time for the bulb to light.




OIL PRESSURE SWITCH CHECK
Check the continuity between the terminals of oil pressure switch and body ground.




DIODE CHECK
^ Check continuity using an ohmmeter.
^ Diode is functioning properly if test results are as shown in the figure.

NOTE: Specification may vary depending on the type of tester. Before performing this inspection, be sure to refer to the instruction for the tester to be used.

^ Diodes for warning lamps are built into the combination meter printed circuit.
^ For location of diodes, refer to Combination Meter.