CONSULT Inspection Procedure

With Consult
SELF-DIAGNOSTIC PROCEDURE (With CONSULT)
1. Turn on CONSULT and touch "ENGINE" for OBD-II detected items or touch "A/T" for TCM self-diagnosis.
If A/T is not displayed, check TCM power supply and ground circuit. If result is NG, refer to "POWER SUPPLY ROUTING".
2. Touch "SELF-DIAG RESULTS".
Display shows malfunction experienced since the last erasing operation.
CONSULT performs REAL-TIME SELF-DIAGNOSIS. Also, any malfunction detected while in this mode will be displayed at real time.

DTC WORK SUPPORT MODE WITH CONSULT
CONSULT setting procedure
1. Turn ignition switch "OFF".




2. Connect CONSULT to Data link connector for CONSULT.
Data link connector for CONSULT is located in left side dash panel.
3. Turn ignition switch "ON".




4. Touch "START".




5. Touch "A/T".




6. Touch "DTC WORK SUPPORT".




7. Touch select item menu (1ST, 2ND, etc.).




8. Touch "START".




9. Perform driving test according to "DTC CONFIRMATION PROCEDURE" in "TROUBLE DIAGNOSIS FOR DTC".




- When testing conditions are satisfied, CONSULT screen changes from "OUT OF CONDITION" to "TESTING".




10. Stop vehicle. If "NG" appears on the screen, malfunction may exist. Go to "DIAGNOSTIC PROCEDURE".







11. Perform test drive to check gear shift feeling in accordance with instructions displayed.




12. Touch "YES" or "NO".







13. CONSULT procedure ended.
If "NG" appears on the screen, a malfunction may exist. Go to "DIAGNOSTIC PROCEDURE".