Remote Controller ID Set Up

CONSULT REMOTE CONTROLLER ID SET UP PROCEDURE

NOTE: If a remote controller is lost, the ID code of the lost remote controller must be erased to prevent unauthorized use. When the ID code of a lost remote controller is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new remote controllers must be re-registered.




1. Turn ignition switch "OFF".
2. Connect "CONSULT" to the data link connector




3. Turn ignition switch "ON".
4. Touch "START".




5. Touch "SMART ENTRANCE".




6. Touch "REMO CONT ID SET UP".





7. The items shown on the figure at left can be set up.
- "REMO CONT ID CONFIR"
Use this mode to confirm if remote controller ID code is registered or not.
- "REMO CONT ID REGIST"
Use this mode to register a remote controller ID code.

NOTE: Register the ID code when the remote controller or smart entrance control unit is replaced, or when an additional remote controller is required.

- "REMO CONT ID ERASUR"
Use this mode to erase a remote controller ID code.