Transfer Control Unit Terminals and Reference Value
REMOVAL AND INSTALLATION OF TRANSFER CONTROL UNITRemoval
1. Turn ignition switch OFF and disconnect negative battery terminal.
2. Remove console box.
3. Remove cluster lid C.
4. Remove audio assembly and A/C control unit.
5. Remove instrument lower panel on driver side.
6. Remove glove box.
7. Remove instrument lower panel on passenger side.
8. Remove instrument lower center panel.
9. Remove transfer control unit.
- For steps 2 through 8 above, refer to "Instrument Panel, Gauges and Warning Indicators.
Installation
- Installation is in the reverse order of removal. When installing transfer control unit, tighten transfer control unit lock nut.
Tightening torque: 4.3 - 5.8 Nm (0.44 - 0.59 kg-m, 38 - 51 inch lbs.)
INSPECTION OF TRANSFER CONTROL UNIT
- Measure voltage between each terminal and terminal 6 or 45 by following "TRANSFER CONTROL UNIT INSPECTION TABLE".
- Pin connector terminal layout
TRANSFER CONTROL UNIT INSPECTION TABLE
(Data are reference values.)
Part 1 of 4
Part 2 of 4
Part 3 of 4
Part 4 of 4