Transfer Motor

REMOVAL





1. Disconnect transfer motor harness connector.
2. Remove breather pipe from transfer motor.
3. Remove bolts to detach transfer motor.
- After removing transfer motor, be sure to replace O-ring with new one.

INSTALLATION
1. Apply petroleum jelly or ATF to O-ring.
2. Align width across flat-notch with oil pump groove, and install transfer motor.
3. Tighten bolts.
Tightening Torque: 41 - 48 Nm (4.2 - 4.9 kg-m, 30 - 35 ft. lbs.)
4. Install breather pipe to transfer motor.
5. Connect transfer motor harness connector.