Fuel Pump: Service and Repair

1. Release fuel pressure from fuel line. Refer to "Fuel Pressure Release".
2. Remove inspection hole cover located behind the rear seat.
3. Disconnect harness connectors and fuel tubes from upper plate of fuel gauge.
- Put mating marks on tubes for correct installation.

4. Remove fuel gauge retainer and fuel gauge.




5. Disconnect the quick connectors as follows.
1. Put mating marks on tubes and connectors for correct installation.
2. Hold the sides of the connector, push in tabs, and pull out the tube inserted in the retainer.

CAUTION:
- The tube can be removed when the push in tabs are completely depressed. Do not twist it more than necessary.
- Do not use any tools to remove the quick connector.
- Keep the connecting portion of the tubes and quick connectors clean.




6. Remove fuel pump with bracket while lifting the pawl of the fuel pump bracket upward.




7. To install, reverse the removal procedure. Connect the quick connectors as follows.
- Be sure that the connecting portion is clean and smooth.
- Align mating marks.
- Insert tube into the center of the connector until you hear a click.

After connecting quick connectors, make sure the connection is firmly made using the following method.




- Pull on the fuel tube and connector to make sure they are firmly connected.
- Start the engine, increase engine speed and verify that there are no leaks.




- Install fuel gauge as shown.