Adjustment

Adjustment





When any parts listed in the following table are replaced, total end play or reverse clutch end play must be adjusted.





1. Adjust total end play.
Total end play "To": 0.25 - 0.55 mm (0.0098 - 0.0217 inch)





a. With needle bearing installed, place J34291-1 (bridge), J34291-2 (legs) and the J34291-5 (gauging cylinder) onto oil pump. The long ends of legs should be placed firmly on machined surface of oil pump assembly. The gauging cylinder should rest on top of the needle bearing. Lock gauging cylinder in place with set screw.





b. Install J34291-23 (gauging plunger) into gauging cylinder.





c. Install original bearing race inside reverse clutch drum. Place shim selecting gauge with its legs on machined surface of transmission case (no gasket). Allow gauging plunger to rest on bearing race. Lock gauging plunger in place with set screw.





d. Remove Tool and use feeler gauge to measure gap between gauging cylinder and gauging plunger. This measurement should give exact total end play.

Total end play "T.": 0.25 - 0.55 mm (0.0098 - 0.0217 inch)
If end play is out of specification, decrease or increase thickness of oil pump cover bearing race as necessary.
Available oil pump cover bearing race: Refer to Application and ID.





2. Adjust reverse clutch drum end play.
Reverse clutch drum end play "T2": 0.55 - 0.90 mm (0.0217 - 0.0354 inch)





a. Place J34291-1 (bridge), J34291-2 (legs) and J34291-5 (gauging cylinder) on machined surface of transmission case (no gasket). Allow gauging cylinder to rest on front thrust surface of reverse clutch drum. Lock cylinder in place with set screw.





b. Install J34291-23 (gauging plunger) into gauging cylinder.





c. Install original thrust washer on oil pump. Place shim setting gauge legs onto machined surface of oil pump assembly. Allow gauging plunger to rest on thrust washer. Lock plunger in place with set screw.





d. Use feeler gauge to measure gap between gauging plunger and gauging cylinder. This measurement should give you exact reverse clutch drum end play.

Reverse clutch drum end play "T2": 0.55 - 0.90 mm (0.0217 - 0.0354 inch)
- If end play is out of specification, decrease or increase thickness of oil pump thrust washer as necessary.
Available oil pump thrust washer: Refer to Application and ID.