H233B

PRE-INSPECTION





Before disassembling final drive, perform the following inspection
- Total preload
a. Turn drive pinion in both directions several times to seatbearing rollers correctly.
b. Check total preload with Tool.
Tool number: ST3127S000 (J25765-A)
Total preload: 1.2 - 2.0 Nm (12 - 20 kg-cm, 10 - 17 inch lbs.)





Ring gear to drive pinion backlash Check backlash of ring gear with a dial indicator at several points.
Ring gear-to-drive pinion backlash: 0.13 - 0.18 mm (0.0051 - 0.0071 inch)





- Ring gear runout Check runout of ring gear with a dial indicator.
Runout limit: 0.08 mm (0.0031 inch)





- Tooth contact
Check tooth contact. Refer to "TOOTH CONTACT", under Service and Repair; Adjustment.
- Side gear to pinion mate gear backlash Measure clearance between side gear thrust washer and differential case with a feeler gauge.
Clearance between side gear thrust washer and differential case: 0.10 - 0.20 mm (0.0039 - 0.0079 inch)