Mainshaft and Clutch Drum

Mainshaft and Clutch Drum





1. Remove mounting bolts to detach baffle plate.





2. Set center case to press stand. Remove mainshaft from center case.





3. Remove thrust needle bearing from press flange.





4. Remove seal ring from mainshaft.
- Do not reuse seal ring.





5. Set a drift (KV31103300), a support ring (KV40104710), a support ring (ST27863000) and a drift (ST35271000) to press flange as shown in the figure. Press drift until snap ring is out of place.





6. Remove snap ring from mainshaft.
- Do not reuse snap ring.





7. Remove washer.





8. Remove press flange from mainshaft.





9. Remove return spring assembly from clutch hub.





10. Remove each plate from clutch drum.





11. Remove snap ring from mainshaft. Do not reuse snap ring.





12. Tap mainshaft with a plastic hammer to remove it from clutch drum and clutch hub.
13. Remove needle bearing from mainshaft.