Vehicle Security System Activation

VEHICLE SECURITY SYSTEM ACTIVATION

Pattern A
With all doors (including hood and glass hatch) closed, if the key is used to lock doors, smart entrance control unit terminal 33 receives a signal from power window main switch terminal 8.
When key cylinder switch is in LOCK position, ground is supplied
- to power window main switch terminal 6
- from terminal 3 of the front key cylinder switch LH
- through terminal 2 of front key cylinder switch LH
- through body grounds M77 and M111, or smart entrance control unit terminal 11 receives a ground signal
- from terminal 1 of the back door key cylinder switch
- through body grounds B11, B22 and D210.

If this signal, or lock signal from keyfob is received by the smart entrance control unit, the vehicle security system will activate automatically.

NOTE: Vehicle security system can be set even though all doors are not locked.

Pattern B
With any door (including hood and glass hatch) open, if lock/unlock switch is used to lock doors, smart entrance control unit terminal 33 receives a LOCK signal
- from terminal 8 of lock/unlock switch LH
- through body grounds M77 and M111, or
- from terminal 11 of lock/unlock switch RH
- through body grounds M4, M66 and M147, or

With any door (including hood and glass hatch) open if the key is used to lock doors, smart entrance control unit terminal 33 receives a LOCK signal from power window main front switch terminal 8.

When key cylinder switch LOCK signal ground is supplied
- to power window main switch terminal 6
- from terminal 3 of the front key cylinder switch LH
- through terminal 2 of front key cylinder switch LH
- through body grounds M9, M25 and M87, or

smart entrance control unit terminal 11 receives a ground signal
- from terminal 1 of the back door key cylinder switch
- through body grounds B11, B22 and D210.

If these signals and lock signal from keyfob are received by the smart entrance control unit, ground signals of terminals 1, 2 and 3 are interrupted and all doors are closed, the vehicle security system will activate automatically.

NOTE: Vehicle security system can be set even though the rear door is not locked.

Once the vehicle security system has been activated, smart entrance control unit terminal 38 supplies ground to terminal 2 of the security indicator lamp.

The security lamp will illuminate for approximately 30 seconds and then blinks every 2.6 seconds.

Now the vehicle security system is in armed phase.