Preliminary Check
Preliminary CheckPreliminary Check:
* 1: After reconnecting battery cable, perform initialization procedure A or B.
If initialization has not been performed, automatic drive positioner will not operate.
PROCEDURE A
1. Insert key in the ignition key cylinder. (Ignition switch is in "OFF" position.)
2. Open -> close -> open driver side door. (Do not perform with the door switch operation.)
3. End
PROCEDURE B
1. Drive the vehicle at more than 30 km/h (19 MPH).
2. End
After performing preliminary check, go to symptom chart.
Symptom Chart
Before starting trouble diagnoses, perform preliminary check.
Symptom numbers in the symptom chart correspond with those of preliminary check.