Removal and Installation

Removal





1. Remove exhaust front and rear tubes.
2. Remove front and rear propeller shaft.
3. Insert plug into rear oil seal after removing propeller shaft.
- Be careful not to damage spline, sleeve yoke and rear oil seal, when removing propeller shaft.
4. Disconnect neutral-4LO switch, front revolution sensor, ATP switch, transfer motor and 4WD shift switch harness connectors.





5. Remove center console and A/T control device.
6. Remove floor panel for transfer.
7. Remove upper side fixing bolt for A/T and TF.
8. Remove actuator lever from transfer outer shift lever and remove sub-oil pump from transfer.
9. Remove remaining fixing bolt for AT and TF.








10. Remove transfer from transmission.

WARNING: Support transfer while removing it.

Installation





- Tighten bolts securing transfer.
Bolt length: 45 mm (1.77 inch)
Tightening torque: 31 - 42 Nm (3.2 - 4.3 kg-m, 23 - 31 ft. lbs.)