ICC Vehicle Speed Sensor
DTC P1574 ICC VEHICLE SPEED SENSORComponent Description
The ECM receives two vehicle speed signals via CAN communication line. One is sent from unified meter and A/C amp., and the other is from TCM (Transmission control module). The ECM uses these signals for ICC control.
On Board Diagnosis Logic:
On Board Diagnosis Logic
- This self-diagnosis has the one trip detection logic.
- The MIL will not light up for this self-diagnosis.
NOTE:
- If DTC P1574 is displayed with DTC U1000, U1001, first perform the trouble diagnosis for DTC U1000, U1001.
- If DTC P1574 is displayed with DTC P0500, first perform the trouble diagnosis for DTC P0500.
DTC Confirmation Procedure
CAUTION: Always drive vehicle at a safe speed.
NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Step 3 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.
WITH CONSULT-II
1. Start engine.
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Drive the vehicle at more than 40 km/h (25MPH).
4. If DTC is detected, go to "Diagnostic Procedure".
WITH GST
Follow the procedure "WITH CONSULT-II" above.
Diagnostic Procedure Step 1 - 3:
Diagnostic Procedure