Self-Diagnostic Function

Consult-II Function:

CONSULT-II Function

DESCRIPTION
CONSULT-II executes following functions by combining data reception and command transmission via communication line from ICC unit.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

1. Turn ignition switch OFF.




2. Connect "CONSULT-II" and "CONSULT-II CONVERTER" to data link connector, which is located under LH dash panel near the hood opener handle.




3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)".




5. Touch "ICC" on the selection screen.
If "ICC" is not indicated, go to "CONSULT-II Data Link Connector (DLC) Circuit" Data Link Connector .




6. Touch any of "WORK SUPPORT", "SELF-DIAG RESULTS", "DATA MONITOR", "ACTIVE TEST" and "ECU PART NUMBER" on selection screen.