Removal and Installation

Removal
1. Disconnect negative battery terminal.
2. Remove engine front undercover using power tools.
3. Remove alternator and power steering belt. Refer to "Removal and Installation" in "ENGINE MECHANICAL.




4. Disconnect alternator connector.
5. Remove B terminal nut.
6. Remove harness clip and water hose bracket from alternator.




7. Remove oil pressure switch harness clip from alternator stay. (2WD)
8. Disconnect oil pressure switch connector. (2WD)
9. Remove alternator stay mounting bolts and alternator stay using power tools.
10. Remove alternator mounting bolt using power tools.
11. Remove alternator assembly to the direction of under side the vehicle.

Installation
Install in the reverse order of removal taking care of the following point.

- Install alternator and check tension of belt. Refer to "Checking Drive Belts" in "ENGINE MECHANICAL".

CAUTION: Be sure to tighten B terminal nut carefully.