Side Distance Guideline Correction

Side Distance Guideline Correction
This mode is used to modify the side distance guidelines if they are dislocated from the rear view monitor image, because of variations of body/camera mounting conditions.

SIDE DISTANCE GUIDELINE CORRECTION PROCEDURE




1. Create a correction line to modify the screen.
Draw lines on the rearward of the vehicle passing through the following points: 0.2 m (7.87 inch) from both sides of the vehicle, and
- *1: 0.5 m (1.5 feet)
- *2: 1 m (3 feet)
- *3: 2 m (7 feet)
- *4: 3 m (10 feet)
and from the rear end of the bumper

2. With the ignition switch OFF, connect "CONSULT-II" and "CONSULT-II CONVERTER" to the data link connector, then turn ignition switch ON. Touch "REARVIEW CAMERA" on CONSULT-II.

CAUTION: Stop engine for the safety when correcting side distance guideline.





3. Shift the A/T select lever is R-range position.




4. Touch "SELECT GUIDELINE PATTERN" on "SELECT WORK ITEM" screen.




5. Touch "UP" or "DOWN", and select the guide line, "PATTERN NO. 0" or "PATTERN NO. 1", which is the closest to the corrected line.
6. Touch "SAVE", and confirm the guide line.
7. Touch "END".




8. Touch "ADJ GUIDELINE POSITION" on "SELECT WORK ITEM" screen.




9. Adjust the guide line touching "X UP", "X DOWN", "Y UP" or "Y DOWN" so that the corrected line can fit the guide line.
10. Touch "SAVE", and confirm the guide line.
11. Touch "END" to finish correcting.