Engine: Specifications

GENERAL SPECIFICATIONS





DRIVE BELT





INTAKE MANIFOLD COLLECTOR, INTAKE MANIFOLD AND EXHAUST MANIFOLD





SPARK PLUG





CYLINDER HEAD

VALVE





Valve Dimensions





Valve Clearance





Valve Spring





Valve Lifter





Available Valve Lifter





Valve Guide





Valve Seat





CAMSHAFT AND CAMSHAFT BEARING





CYLINDER BLOCK

PISTON, PISTON RING AND PISTON PIN





Available Piston





Piston Ring





Piston Pin





CONNECTING ROD





CRANKSHAFT





AVAILABLE MAIN BEARING





Undersize





CONNECTING ROD BEARING





Undersize





BEARING OIL CLEARANCE








Cylinder head bolts.
Step a 98.1 Nm (10 kg-m, 72 ft. lbs.)
Step b Completely loosen 0 Nm (0 kg-m, 0 ft. lbs.)

CAUTION: In step "b", loosen bolts in the reverse order of that indicated in figure.

Step c 39.2 Nm (4.0 kg-m, 29 ft. lbs.)
Step d "90" degrees clockwise (angle tightening)
Step e "90" degrees clockwise again [target: 90 degrees (angle tightening)].





Intake Manifold bolts.
1st step 7.4 Nm (0.75 kg-m, 5 ft. lbs.)
2nd step 29.0 Nm (3.0 kg-m, 21 ft. lbs.)
3rd step and after 29.0 Nm (3.0 kg-m, 21 ft. lbs.)





Camshaft brackets.
Step a; No. 7 to 10, then tighten No. 1 to 6 in order as shown 1.96 Nm (0.20 kg-m, 1 ft. lbs.)
Step b; No. 1 to 10 in numerical order as shown 5.9 Nm (0.60 kg-m, 4 ft. lbs.)
Step c; No. 1 to 6 in the numerical order as shown 10.4 Nm (1.1 kg-m, 8 ft. lbs.)
Step d; No. 7 to 10 in the numerical order as shown 9.3 Nm (0.95 kg-m, 7 ft. lbs.)





Main bearing cap bolt.
Step a; Apply new engine oil to threads and seat surfaces of mounting bolts.
Step b; Tighten bolts in numerical order with tightening torque in several different steps 35.3 Nm (3.6 kg-m, 26 ft. lbs.)
Connecting rod bolt
Step a; Apply engine oil to the threads and seats of the connecting rod bolts.
Step b; Tighten bolts 19.6 Nm (2.0 kg-m, 14 ft. lbs.)
Step c; Then tighten all bolts "90" degrees clockwise (Angle tightening).
Crankshaft Pulley Bolt 44.1 Nm (4.5 kg-m, 33 ft. lbs.)
Drive Plate 88.2 Nm (9.0 kg-m, 65 ft. lbs.)
Oil Pump Torque 7.0 Nm (0.71 kg-m, 62 inch lbs.)








Exhaust Manifold stud bolts 14.7 Nm (1.5 kg-m, 11 ft. lbs.)
Water Pump Bolts 9.6 Nm (1.0 kg-m, 87 inch lbs.)